目標器件：復旦微FPGA：JFM7K325T8FCBGA676（對標Xilinx Kintex-7系的XC7K325T）

工程背景：送入FPGA的外部時鐘為差分時鐘，時鐘送入FPGA后，經過PLL輸出至DDR3，但在implementation時失敗

bug message：

[Place 30-172] Sub-optimal placement for a clock-capable IO pin and PLL pair. If this sub optimal condition is acceptable for this design, you may use the CLOCK_DEDICATED_ROUTE constraint in the .xdc file to demote this message to a WARNING. However, the use of this override is highly discouraged. These examples can be used directly in the .xdc file to override this clock rule.
< set_property CLOCK_DEDICATED_ROUTE BACKBONE [get_nets clk_wiz_0_inst/inst/clk_in1_clk_wiz_0] >

clk_wiz_0_inst/inst/clkin1_ibufgds (IBUFDS.O) is locked to IOB_X1Y72
clk_wiz_0_inst/inst/plle2_adv_inst (PLLE2_ADV.CLKIN1) is provisionally placed by clockplacer on PLLE2_ADV_X1Y0

The above error could possibly be related to other connected instances. Following is a list of
all the related clock rules and their respective instances.

Clock Rule: rule_pll_bufg
Status: PASS
Rule Description: A PLL driving a BUFG must be placed on the same half side (top/bottom) of the device
clk_wiz_0_inst/inst/plle2_adv_inst (PLLE2_ADV.CLKFBOUT) is provisionally placed by clockplacer on PLLE2_ADV_X1Y0
and clk_wiz_0_inst/inst/clkf_buf (BUFG.I) is provisionally placed by clockplacer on BUFGCTRL_X0Y0

 原因分析：

The IO port and PLL are not in same clock region hence you are seeing the error. 

解決辦法：

將IO Ports送入的時鐘信號通過IBUFG，然后送入PLL，即可解決，本工程中因?yàn)椴捎玫牟罘謺r(shí)鐘輸入，所以原語選用IBUFGDS，生成的單端時鐘送入PLL，PLL的時鐘source選擇 Global buffer，解決